#4 Stone vs #57 Gravel: Size, Cost, and Which to Use
#4 Stone runs about $20 per ton and #57 Gravel about $20 per ton. Compare size, drainage, compaction, and which one to use.
Overview
Sieve size #4 in the ASTM aggregate grading means most of the stone passes a 1.5-inch screen and stays on a 3/4-inch screen. In practice you get a pile of roughly walnut to golf ball sized rock. Every piece is angular because it was crushed, and those sharp edges lock together under load instead of rolling like river stone. Because it is washed or screened clean, there are no fines to fill the gaps between pieces. That is the whole point: about 35 to 40 percent of a pile of #4 is air, so water moves through it fast.
The 57 comes from the ASTM C33 grading table. Size #57 means most of the stone passes a 1-inch screen and stays on a #4 sieve (about 3/16 inch), with the bulk of it between 1/2 and 1 inch. It is "clean" stone, so there are no fines. That leaves about 35 percent air space in a pile, which is why it drains so well and why it stays loose on its own.
Common Uses
#4 Stone
- ✓ Driveway and road base
- ✓ Drainage beds
- ✓ Retaining wall backfill
- ✓ Construction entrance pads
- ✓ Pipe bedding for large pipe
- ✓ Erosion control
#57 Gravel
- ✓ Driveways
- ✓ French drains
- ✓ Concrete mix
- ✓ Pipe bedding
- ✓ Backfill
- ✓ Parking pads
- ✓ Septic systems
Pros & Cons
#4 Stone
- + Excellent drainage with 35 to 40 percent void space
- + Bridges soft ground better than smaller stone
- + Cheap, $20 to $40 per ton, and stocked everywhere
- + Angular pieces lock together under load
- + Same price as #57 with more drainage capacity
- − Too coarse to walk on or drive on as a surface
- − Needs a finer cap layer for any traffic
- − Hard to rake and spread by hand
- − Sinks into soft clay without fabric
#57 Gravel
- + Cheapest useful stone at $20 to $35 per ton
- + Stocked at every quarry in the country
- + Drains fast, about 35 percent void space
- + Angular pieces interlock under load
- + Works for driveways, drains, concrete, and backfill
- − Too coarse to walk on comfortably
- − Stays loose, rolls to the edges under tires
- − Needs a finer top layer on driveways
- − Not decorative
Cost Comparison
| Measure | #4 Stone | #57 Gravel |
|---|---|---|
| Per ton | $20 – $40 | $20 – $35 |
| Per cubic yard | $25 – $55 | $25 – $45 |
Sizes & Colors
#4 Stone
#4 stone is crushed rock screened to pieces between 1 and 1.5 inches, with some quarries running it up to 2 inches. It is angular with sharp fractured faces. Color follows the quarry: gray or blue-gray limestone in the Midwest and Northeast, gray to pink granite in the Southeast, tan limestone in Texas.
#57 Gravel
#57 gravel is angular crushed stone screened to 3/4 inch to 1 inch, with a few pieces down to 1/2 inch. Color depends on the quarry: gray or blue-gray limestone through the Midwest and Northeast, gray, white, and pink granite in the Southeast, tan limestone in Texas, and dark basalt in the Northwest.
Published September 02, 2026
Compare prices from local suppliers
Get quotes from gravel suppliers near you to find the best deal.