GoodGravel

Crusher Run in Scottsdale, AZ

Is Crusher Run Used Frequently in Scottsdale?

Crusher Run is a popular choice among homeowners and contractors in Scottsdale. With 1 local supplier carrying it, you should have no trouble finding crusher run for your project.

Crusher run is crushed stone with the rock dust left in, sold as 3/4 inch minus or 1.5 inch minus. It costs $20 to $35 per ton in 2026, weighs 1.5 to 1.7 tons per cubic yard, and packs into a surface hard enough to drive on year after year. It is the standard base under roads, driveways, parking lots, and patios, and the best single-layer material for a gravel driveway. In the Southeast it is called crush and run. Highway departments call it aggregate base course, ABC, or Class 5. ## Why Crusher Run Packs So Hard A pile of clean #57 stone is about 35 percent air. Crusher run fills that air with smaller stone, sand, and dust. When you wet it and run a plate compactor or a loaded truck over it, the fines lock the larger pieces in place and the whole layer knits together. Compaction is about 15 percent, so a 6-inch loose layer ends up about 5 inches. The finished surface sheds rain, holds tires without rutting, and can be graded smooth with a box blade. Given a few months of traffic, a crusher run driveway feels closer to pavement than to gravel. The trade-off is drainage. Water runs off crusher run instead of through it. That is fine on a crowned driveway with somewhere for water to go. It is the wrong choice inside a French drain or behind a retaining wall. ## What Crusher Run Is Used For - **Gravel driveways.** Four to 6 inches on firm ground, compacted in two lifts, makes a complete driveway with no other layers. On soft clay, put 4 inches of #4 stone under it. - **Parking lots and pads.** The go-to surface for gravel parking, RV pads, and equipment yards. Six inches for cars, 8 to 12 inches in two layers for trucks. - **Road base.** Under asphalt and concrete roads, crusher run is the structural layer that carries the load. - **Paver and patio base.** Four inches of compacted crusher run under 1 inch of sand or stone dust is the standard paver base. - **Shed and hot tub pads.** Compacts flat and stays flat. - **Walkways.** Packs into a firm path, though it is dusty when dry and a bit muddy when wet. Decomposed granite or #89 stone is nicer underfoot. - **Filling potholes and ruts.** The fines make it bind to the old surface instead of rolling out. ## 3/4 Minus Versus 1.5 Minus Most quarries sell two sizes. 3/4 inch minus is finer and gives a smoother finished surface, so it is the pick for driveway tops, paths, and paver base. 1.5 inch minus has bigger top-size stone, spreads loads better, and is the pick for the bottom of a thick driveway or a truck lot. Some quarries call the coarser one "#4 down" or "crusher run base" and the finer one "#57 down" or "crusher run surface." ## Installing Crusher Run Grade the subsoil with a slight crown or a 2 percent slope so water leaves. Lay geotextile fabric if the soil is clay. Spread crusher run in 3-inch lifts, wet each lift lightly with a hose, and compact it with a plate compactor (rent one for about $90 a day) or drive a loaded truck back and forth. Keep going until the surface stops moving. A driveway done this way needs a fresh inch on top every 2 to 3 years and almost no other maintenance. ## What Crusher Run Costs At $20 to $35 per ton it is among the cheapest materials a quarry sells. Because it is dense, a ton covers less area than a ton of #57: about 55 square feet at 4 inches. A 12 x 40 ft driveway at 4 inches needs about 10 tons, one single-axle load, for $200 to $350 plus delivery. Read the [gravel driveway cost guide](/gravel/costs/gravel-driveway-cost) for full project pricing. [Recycled asphalt](/gravel/types/recycled-asphalt) is the only common driveway material that is cheaper, and the two are compared [here](/gravel/types/compare/crusher-run-vs-recycled-asphalt). ## What to Avoid Do not use crusher run for drainage, inside a French drain, around drain pipe, or behind a retaining wall. Do not use it as a play area surface or in garden beds, where the fines turn to a crust. Do not spread it in one thick lift; it will not compact past the top 3 inches. And do not expect a dust-free surface in dry weather. Limestone crusher run in particular tracks white dust into the house until it seals over.

How Much Crusher Run Do I Need?

Draw your project area on the map to get an instant material estimate for Crusher Run in Scottsdale.

Plan your gravel project

Type your address, trace the area on a satellite photo, and see how many tons to order.

Typical Uses in Scottsdale

  • Single-layer gravel driveways
  • Parking lots and RV pads
  • Road and driveway base
  • Paver and patio base
  • Shed pads
  • Pothole and rut repair

Cost of Crusher Run in Scottsdale

Measure Estimated Range
Per ton $20 – $35
Per cubic yard $25 – $45

Prices vary by supplier, quantity, and delivery distance. Contact local suppliers for exact quotes.

Crusher Run Suppliers in Scottsdale

BaseCore

7845 E Gelding Dr, Scottsdale, Arizona

Crusher Run

Need Crusher Run Delivered?

Get quotes from local gravel suppliers in Scottsdale.